The shower can be a very frightful place when all those soap suds start to acquire on the floor of your shower. A method to feel safer in the shower is to mount a grab bar to the wall. Here are the tools you will need and directions to properly put in a grab bar in your tiled bathroom shower.
Once you have acquired a grab bar you must gather the tools needed to install it. The following are the tools you will need :
Philips-head screwdriver
Drill
one / 8 in. masonry bit or glass and tile bit
Stud finder or a length of wire
Tape measure
Silicone caulk
sharp awl or carbide glass and tile drill bit
Wood bit, one / sixteen narrower than the scale of mounting screws
The very first thing that you will need to do to install your grab bar is to locate a wall stud. If you can access to a stud finder this will assist greatly. Run the stud finder along the wall until a wall stud is located and mark the spot with a fine point marker. If you don’t have an electronic stud finder, no problems, just take a 1 / 8 masonry bit or glass and tile bit and simply drill a hole into the grout. Then get your length of wire and make a bend in it. Place the wire in the hole and by spinning it left and right you need to hit a stud. If you do not find a stud, the hole that you drilled can be stuffed with a slight bit of silicone caulk. Be efforts to flatten the dab of silicone caulk so it doesn’t protrude from the grout line, permit the caulk to dry for roughly 3 hours. If you have powdered grout handy, combine a bit and patch the hole. Re-drill another hole till you find a stud. When you do locate a stud, measure 16 inches from that hole and you should be in a position to drill into another stud.
You will need to mark your stud locations so you can measure from the base of the tub to pinpoint the placement of your bar. Position your bar so that each end is over a stud and mark the screw holes that are in the mounting bracket.
To drill the mounting holes into tile you may have to make a place to begin for the drill bit or else the bit will run across the tile. To make a place to begin use a sharp awl or afore discussed drill bit. Using your hand, twist the instrument on your make to make a slight impression on the tile ; this will keep your drill bit from slipping. Don’t use a punch or you are likely to crack your tile. Use the glass and tile bit to drill your hole. If employing a masonry bit, place tape over the tile and drill slowly to avoid breaking the tile. You don’t want to break your tiles when screwing the mounting brackets on either so use a bit that is third two wider than the dimensions of the mounting screw you’ll be using. Start drilling the hole slowly and with even pressure so as not to slide off your mark. Utilize light pressure when drilling to keep from cracking the tile.
Make sure not to drill deeper than the tile and it backing. At about that point, you will need to change your bit to the wood bit one / 16 narrower than the screw. This will make a pilot hole in the studs.
The final step is to fasten the bar. Silicone caulk will need to be put onto the holes before mounting ; this is to guard the wood and backing boards behind the tiles from leaking water. Merely screw the bar to the wall. You’ll wish to use chrome steel screw or they will rust. Tighten the screws firmly making sure to not over tighten them or they can crack the tile.
You should now have your grab bar properly installed. You can now take a tranquil, relaxing shower and feel safer in the process. To find keywords be sure to shop all the chief bathroom remodel and bathroom remodeling manufacturers sites.